Heed Audio CanAmp, headphone amplifier


Availability: In stock

Levertijd 1-2 dagen

The CanAmp is a two-stage amplifier. While th..

Heeft u een vraag over dit product?

026 84 878 47info@tweaks4u.comLivechat: online


The CanAmp is a two-stage amplifier. While the first - voltage gain - stage is based on an integrated circuit of the highest audio pedigree, the second - power gain - stage is a single-ended, pure Class-A amplifier. It enables the CanAmp to drive virtually any headphones from 32 ohms up to 600 ohms. The unit has no internal wiring, and the signal path is kept to a minimum on its PCB. Its high-quality, 1 dB-tolerance Blue Alps volume pot goes through a further selection process during manufacturing to achieve an even tighter, 0.5 dB tolerance.

The CanAmp not only has a line-level input but offers a line-level output to boot; it can therefore be connected to the TAPE MONITOR output of an amplifier, leaving the TAPE output free for additional components (MP3, MiniDisc, CDR, etc.). Gold-plated RCA terminals are used, and soldered directly onto the fibreglass PCB.

Technical specifications:
Input sensitivity/impedance: 200 mV/10 kOhm
Power output: 300 mW (100 Ohm)
Signal-to-noise ratio (unweighted): 85 dB
Distortion (THD, 1 kHz, 100mW): <0,05%
Frequency range: 10 Hz-50 kHz (±0,5 dB)


Please wait...